CWTS: Certified Wireless Technology Specialist Official Study Guide: Exam PW0-070ISBN: 978-0-470-43889-3
Paperback
504 pages
June 2009
 This title is out-of-print and not currently available for purchase from this site.
View Most Recent Edition of This Title
Other Available Formats: E-book
|
Do you think you've discovered an error in this book? Please check the list of errata below to see if we've already addressed the error. If not, please submit the error via our Errata Form. We will attempt to verify your error; if you're right, we will post a correction below.
| Chapter | Page | Details | Date | Print Run |
|---|---|---|---|---|
| 1 | 13 | Text correction: Incorrect data rates in WLAN standards 802.11a and 802.11g There are two instances on page 13 in which the same error is included. The last two bullet points of the lists under 802.11a and 802.11g: "6, 9, 12 Mbps OFDM required data rates 18, 24, 36, 48, and 54 Mbps OFDM data rates are supported but not required" are incorrect. They should read: "6, 12, and 24 Mbps OFDM required data rates 9, 18, 36, 48, and 54 Mbps OFDM data rates are supported but not required" |
9/3/09 | 1st |
| 2 | 48 | Correction to Figure 2.16: Standard Ethernet pin assignment The figure is incompletely and incorrectly labeled. The leftmost pair, identified as Pair 3, should be labeled "Pair 2 Orange". The topmost label, Pair 2, should be "Pair 3 Green". The center pair, Pair 1, is correctly labeled Pair 1, but should also be identified as Blue. The rightmost pair, Pair 4, is also correct, but should be identified as Brown. The figure illustrates the EIA/TIA 568B standard. A downloadable version of the corrected image is available on the Resources and Downloads tab. |
3/26/10 | |
| 6 | 170 | Correction: Incorrect entry in Table 6.1 The entry for "Weight" is incorrect. It should read "0.52 oz. (15g)" |
11/4/09 | 1st |
| 6 | 172 | Text correction: Incorrect horizontal beamwidth given for patch/panel antennas The third sentence under "Patch/Panel Antennas": "A patch/panel antenna can have a horizontal beamwidth of as high as 180°, but usually the horizontal beamwith is between 50° and 80°." contains inaccuracies. It should read: "A patch/panel antenna can have a horizontal beamwidth of as high as 180°, but usually the horizontal beamwith is between 35° and 60°." Additionally, add a sentence following that one that reads: "The vertical beamwidth usually ranges between 30° and 80°" |
11/4/09 | 1st |
| Corrections to flashcards on the CD 141: Incorrect answer given. Should be 25dB 158: To be more consistent with the supporting text in the book, the question should refer to radio-chains, not "radios". 216: Answer given is a duplicate of the answer to 217. The correct answer is "An existing wireless network is a potential source of interference." 220: Question is ambiguous. Change the question to read "What length of RF cable will cause loss in a wireless LAN system?" Change the answer to read "An RF cable of any length will cause some loss in a WLAN system." |
1/21/11 | 1st | ||
| CD | Bonus Exam 1, Question 14: Incorrect answer given The answer given, B. High power, wide bandwidth, is incorrect. The correct answer is C. Low power, high bandwidth. |
1/21/11 | 1st |
